S - Line ( Low noise pipes and fitting)

Peštan silent piping system is a promoted version of Peštan HTPP home sewage system and it is specially designed for installation in places where sound insulation is taken into account. Installed with special pipe clamps (with profiled rubber ring) provides reduction in noise an acoustic vibrations up to level of 12 dB*. The latest technology of three-layer extrusion pipe and materials modified with mineral additives have raised disposal of waste water systems within the building structure on a higher level.

Resistance to elevated temperature:

Complete program Peštan S LINE pipes and fittings for sewerage inside buildings resistant to constant heat load of + 60 ° C, as well as short-term thermal load of + 95 ° C.

Physical properties of materials

The density of 9 g / cm3, according to ISO 1183
Tensile strength of 28 MPa according to ISO 527
Modulus of stretching 1,300 MPa according to ISO 527
Impact strength according to Sharpy 70 kJ / m², according to ISO 179

 

Chemical resistance of materials

Peštan S LINE pipes and fittings are resistant to salt water, alcohol, acids, alkalis, sulphates, aggressive gas and all kinds of detergents. On the other hand, can not be used for the transport of water which contains high percentage of benzene, benzine (petrol) or acetone.

Testing of internal sewage is mandatory in modern residential construction.

The pipeline should not overlap prior to the execution of the test, all connections must be visible and clean. All openings must be temporarily closed during the test water resistance. The water with which the watertightness is tested should be dry. Overpressure testing water resistance ranges from a minimum of 0.03 bar to 0.5 bar maximum. Tightness test takes an hour. Criteria for passing the test water resistance is to not lose more than 0.5 liters / hour for every 10 m2 of internal surface of the pipeline.

 

Reduction of noise
 

There are two types of noise that vary widely in the medium through which is transmitted:

The noise of airborn (Airborn noise)
The noise that is transmitted through the walls of buildings (Structure-borne noise)

Both types of noise can be reduced to optimal levels in different ways.

-The noise of airborn

(Airborn noise) is reduced so that the pipes and fittings produced by special technology of special materials (materials reinforced-modified mineral additives) or by optimizing the use of fittings in places change of direction of the pipeline.

 

-Structure-born noise
 

The noise that is transmitted through the walls of buildings (Structure-borne noise) is reduced so that the pipeline is installed properly with good quality clamps with molded rubber (fixed points) and the optimum tightening clamp (slip point).

To determine the effectiveness of the sound insulation, the system of pipes and fittings for house sewage installations, Peštan S LINE system was sent for testing at the renowned German Fraunhofer Institute for Building Physics (IBP) in Stuttgart.

The tests were carried out according to EN 14366 (Laboratory measurement of noise from waste water installations) and DIN 4109 (Sound insulation in buildings – Requirements and verifications) and Peštan S LINE system has shown excellent results with the measured noise level of just 12dB (A ).

Address

Street Marshal Tito 3/A , Tetovo North Macedonia 1200 

Email

Phone

+389 44 341 636

+389 77 691 535

Contact Us
  • Facebook
  • Instagram

Ane Company MB - Tetovo All right reserved ®